Siruba+l818fm1+error+list+2021

For computerized errors, try turning the machine OFF and ON again to clear temporary glitches.

: Inspect the position detector wires and connections. E9: Solenoid Defect siruba+l818fm1+error+list+2021

The L818FM1 runs at 7,000 stitches per minute. The encoder cable (part # CAB-ENC-01) rubs against the machine frame. By 2021, Siruba changed the cable routing, but older 2021 batches still had chafing issues. Inspect the cable near the motor mounting bracket. Use a nylon cable tie to lift it away from moving parts. For computerized errors, try turning the machine OFF

Signals that the position detector signals are broken or the connector is loose. Physical Troubleshooting and Maintenance The encoder cable (part # CAB-ENC-01) rubs against

Errors like ERR3 or E7 often relate to the needle bar not being at the correct "Up" or "Down" position.

The machine or motor is physically jammed. Check for thread tangles in the bobbin or hook area, or check if the motor connector is loose. Motor Connector Signal